Zhermack Zetaplus Soft Putty + Light + Activator II

C-Silicone Rubber Base Impression Material

25% OFF

Rs.1,800.00 Rs.2,400.00

Out of stock

Available offers

  • SAVE ₹100 Delivery Charges on Order Above ₹5,000.
  • SAVE ₹200 Discount on Order Above ₹10,000.
  • SAVE ₹500 Discount on Order Above ₹20,000.
SKU: AMZM029 Categories: , , , Brand:

Related products

Description

Polysiloxane (condensation silicone)
This soft to mix, with elastic setting putty is suitable for any clinical situation and is particularly recommended for the single-stage technique.
APPLICATION:
Zetaplus: Polysiloxane for the first impression characterised by initial flow in the working phase and high rigidity after hardening. Recommended for the two stage technique (double impression)
Zetaplus Soft: Polysiloxane for the first impression characterised by initial flow in the working phase and adequate elasticity on removal from the oral cavity. Recommended for the two stage technique (double impression)
Oranwash VL: Low viscosity, extremely fluid, hydrocompatible, polysiloxane. Recommended for the two stage technique (double impression)
Oranwash L: Low viscosity, extremely fluid, hydrocompatible, polysiloxane. Recommended for the two stage technique (double impression)
Thixoflex M: Low viscosity, thixotropic, hydrocompatible, polysiloxane. It does not drip when injected directly onto the preparation, yet flows easily. Recommended for the two stage technique (double impression) and a single phase (simultaneous) and for the relining of removable prosthesis.
Characteristics
High initial flowability and excellent rigidity after hardening for the putties
Thixotropy for the washes
High tear resistance
Advantages
Excellent relation between rigidity and elasticity
Ideal working time/setting time ratio
High flowability and accuracy of wash materials
Putty and wash materials with the same catalyst
Image Courtesy: Zhermack SpA

Brand

Zhermack

KEY Specifications

TECHNICAL SPECIFICATIONS: Type of setting Normal Set Working time* (min:s) 1:15 Time in mouth* (min:s) 3:15 Setting time* (min:s) 4:30 ISO 4823 Type 0 Putty Consistency Strain in compression 2 - 5 % Elastic recovery > 98 % Linear dimensional change (after 24 h) < 0.2 %

Directions To USE

Dosage: Use the measuring spoon to dose the required quantity of Zetaplus and spread it out over your hand (note: for the correct dosage the putty should be level with the top of the measuring scoop). Press the rim of the measuring scoop onto the putty once for each measure dosed. For each measure of material, apply two strips of Zhermack Indurent Gel as long the measuring scoop (4 cm.) When using Zhermack Indurent Liquid, dose 5 – 6 drops of hardening liquid for each scoop of putty used. Mixing: Fold and knead the putty energetically with your fingertips for about 30 sec., until the colour is even, without any stripes Spread out the putty over the impression tray. The working time including mixing time is about 1 min. 15 sec. Put into the mouth and wait until it is set, which will take about 3 min. 15 sec.

Packaging

1 900 ml tub 900 ml (1.53 kg) 1 x 140 ml Oranwash VL 1 x 60 ml Indurent Gel