Zhermack Zetaplus C Silicone Impression Material | Putty – 900ML Base Only

7% OFF

Rs.1,390.00 Rs.1,500.00

Free Shipping On Orders Above Rs. 2500.00


High performance condensation silicones for impressions in fixed and removable prostheses.
It is commonly used to get impressions in the preparation of crowns, bridges, onlays, and inlays. In some cases,
it’s used for an impression in the process of preparation for complete dentures.

A Zhermack quality guarantee, for over 35 years.

More economical than addition silicones or polyethers
They are characterized by a good accuracy and an ideal working time/setting time ratio.
Pressure, moisture and heat, which are conditions that prevail when introducing the impression tray in the oral cavity, immediately increase the fluidity of the material and
guarantee an impression taking that is very precise along the edges.




#. The different scents, from mint to orange, are pleasant for the patient and professionals.
#. Variable working and setting times according to catalyst quantity (Indurent gel)
#. Reduces mucous compression in the phase of insertion in the oral cavity.
Excellent hardness after setting.
#. In the two-stage technique, it acts perfectly as a special tray, In double mixing, it adapts to the consistency of low viscosity fluid.
#. Variable working and setting times according to catalyst quantity (Indurent gel)
#. Safe disinfection with Zeta 7 Solution and Zeta 7 Spray.
#. Excellent relation between rigidity and elasticity
#. Ideal working time/setting time ratio
#. High flowability and accuracy of wash materials
#. Putty and wash materials with the same catalyst.
#. High initial flowability
#. Green color
#. Spearmint flavor

KEY Specifications

ISO 4823 - ADA 19 Type 0 Putty Consistency
Mixing time 30''
Total working time (23°C/73°F) 1' 15''
Time in mouth 3' 15''
Setting time (23°C/73°F) 4' 30''
Compressive deformation (min-max) 2 -5 %
Elastic recovery >98%
Dimensional stability (after 24 h) <-0.2%

Directions To USE

#. STEPS -
Prepare a tooth for a crown.
After applying GC Tray adhesive, Zhermack Zetaplus putty is loaded on the stock tray.
The putty impression is taken.
Using the putty cutter creates a space for the light body.
Inject the Zhermack Zetaplus light body around the prepared tooth, then immediately re-seat the putty tray impression.
The final impression is taken.
Clear color contrast to reduce the risk of error, consequently saving time and material.
Ideal balance between working time and setting time. (Snap-set effect).
The optimal dosage of the catalyst increases the available working time and reduces contraction
Increased flowability and extreme dimensional stability are achieved thanks to SAS (Synthetic Amorphous Silicas) high-activity spheroid fillers.


1 X 900ML Putty