IVOCLAR Te-Econom Plus Refill

Composite Restorative Material

59% OFF

Rs.495.00Rs.650.00

Buy Now

Available offers

  • SAVE ₹100 Delivery Charges on Order Above ₹5,000.
  • SAVE ₹200 Discount on Order Above ₹10,000.
  • SAVE ₹500 Discount on Order Above ₹20,000.
SKU: AMIC011 Categories: , , Brand:

IVOCLAR Te-Econom Plus Universal Shade A1

sold out Rs.495.00 Rs.1,200.00

IVOCLAR Te-Econom Plus Universal Shade A2

sold out Rs.595.00 Rs.1,200.00

IVOCLAR Te-Econom Plus Universal Shade A3

sold out Rs.650.00 Rs.1,200.00
Brand:

Description

Light-curing, radiopaque hybrid composite

Brand

Ivoclar

FeaturesExcellent physical properties Good polishability High radiopacity Long Working time Proven Ivoclar Vivadent technology and quality
Indications

Restorations of Classes I to V

KEY Specifications

Storage temperature 2–28 °C (36–82 °F)

Directions To USE

Select the shade. For facilitated access to the treatment field, the flexible and patient-friendly mouth opener OptraGate can be used. Establish sufficient isolation, preferably with a rubber dam (complete isolation is ensured with, for example, the anatomically shaped OptraDam Plus). Prepare the cavity according to the requirements of the adhesive technique. Clean the cavity with water spray. Air dry the cavity. Apply a pulp protector (calcium hydroxide) if needed; only cover areas close to the pulp and subsequently apply a pressureresistant cement (e.g. Vivaglass Liner). Place a matrix (e.g. the selectively thinned OptraMatrix) and an interdental wedge, if required. Apply Eco-Etch on the enamel and then on dentin and allow a reaction time of 30 seconds on enamel and 15 seconds on dentin. After that, thoroughly rinse with water spray and dry the tooth surfaces with oil-free compressed air. Avoid dehydrating the dentin. Apply a generous amount of Te-Econom Bond on enamel and dentin, using the enclosed applicator brush. Brush the material gently into the dentin for 10 s. Next, evaporate any remaining solvent with a slow stream of air. Lightcure the adhesive according to the curing time recommendations below. Ensure complete coverage of the preparation surface. Apply Te-Econom Flow in layers of a max. of 2 mm and light cure according to the curing recommendations below. Apply Te-Econom Plus in layers of max. 2 mm and adapt/contour the material with a suitable instrument (e.g. OptraSculpt). The OptraContact instrument can be used to selectively position high-quality proximal contacts. Polymerize each layer individually according to the table below. Hold the light emission window as closely as possible to the surface of the restorative material. Finish the restoration with suitable finishers or fine diamonds. Subsequently, check the occlusion. Polish with silicone polishers (e.g. OptraPol Next Generation).

Packaging

1 X 4GM Syringe