AXIMACK AXO Lute | Convenient Self Curing, Fine Particle, Flouride Releising, Glass Ionomer Luting Cement For Crowns, Bridge, Securing Inlays, Onlays, Post And Orthodontic Bands

30% OFF

Rs.840.00 Rs.1,200.00

Out of stock

Available offers

  • SAVE ₹100 Delivery Charges on Order Above ₹5,000.
  • SAVE ₹200 Discount on Order Above ₹10,000.
  • SAVE ₹500 Discount on Order Above ₹20,000.


#. Cementation Of Inlays, Onlays And Crown.

#. Cementation Of Posts And Screws

#. Attachment Of Metal Orthodontic Bands

#. High Fluoride Release

#. Low Solubility

#. Translucent Shades

#. Very Low Film Thickness



KEY Specifications

Radiopaque glass ionomer Luting cement.
For use only by a dental professional in the recommended indications.

Recommended Indications
1.Cementation of metal or porcelain fused to metal crowns, bridges, inlays.
2.Cementation of stainless steel crowns or orthodontic appliances retained with stainless steel crowns. 3.Cementation of orthodontic bands
4.Base or liner

#. Contraindications
1.Pulp capping
2.In rare cases the product may causes sensitivity in some people. If any such reactions are experienced, discontinue the use of the product and refer to a physician.
Test conditions : Temperature: 23+/- 1 0c , Relative humidity 50 +/- 10% .
ISO 9917 : 1991( E) Dental water based cement
1.Powder and Liquid dispensing
•The standard powder to liquid ratio is 1.8 / 1.0 g. One level scoop of powder to 2 drop of liquid. •For accurate dispensing of powder, lightly tap the bottle against the hand. Do not shake or invert. •Hold the liquid bottle vertically and squeeze gently.
•Close bottle immediately after use.
•Dispence powder and liquid on to the pad. Using the plastic spatula, add all the powder to the liquid. Mix rapidly for 20 seconds.

Note :
For larger amount,divide the powder in to two equal parts.Mix the first portion with all the liquid for 5 seconds. Incorporate the remaining portion and mix the whole thoroughly for 15 seconds.
( Total 20 seconds)

Cementation Technique
a.Prepare tooth using standard techniques. For pulp capping, use calcium hydroxide. b.Clean with pumice and water only.
Wash and dry but do not desiccate. Do not remove smear layer.
c.Clean and dry inside of casting or stainless steel crown
d.Mix the required amount of cement.
e.Cementation :
i.Cementation of cast metal crown or bridges:
Coat internal surface of restoration with 1 mm of cement and start to seat within 30 seconds of completing mix ( Do not overfill ). Higher temperature shorten working time.
ii.Cementation of stainless steel crowns:
Fill the adaptted crown with cement and seat. Note : To facilitate removal of the orthodontic appliances, coat the occlusal surfaces of the teeth to be cemented with fluoride Gel or Petroleum jelly prior to cementation.
f.Setting time is 4 minutes 30 seconds after start of mixing. Remove excess cement at the first formation of gel stage

Store at temperature of 4 to 25 0c ( 39..2 to 77.0 0F). Shelf life : 3years from the date of manufacture