1 1

IVOCLAR Tetric N-Bond | Total Etch Dental Adhesive

IVOCLAR Tetric N-Bond | Total Etch Dental Adhesive

Rs. 1,950.00 Rs. 2,746.00 29% Off
Rs. 1,950.00
Taxes included. Shipping calculated at checkout.
Inclusive of all taxes

Cash On Delivery (COD) Payment Service Available

Save Extra with 3 offers

Save Rs. 500 Discount on order above Rs 20,000

Save Rs. 200 Discount on order above Rs 10,000

Save Rs. 100 Delivery charges on orders above Rs 5,000

Description

IVOCLAR Tetric N-Bond is a light-curing total-etch adhesive formulated for direct and indirect restorations. It is designed to deliver reliable bond strength to both enamel and dentin, supporting long-term clinical success. The nano-filled formulation promotes uniform application and forms a glossy, homogeneous layer that enhances adhesion and coverage.

Tetric N-Bond contains ethanol as a solvent and is free of acetone, which allows for controlled, single-layer application and helps minimize post-operative sensitivity. It is compatible with a wide range of light-cured restorative materials and is intended for use following enamel and dentin etching.

Information

  • Brand: Ivoclar
  • Features: #. Total-etch adhesive for direct and indirect restorations

    #. Reliable bonding to both enamel and dentin

    #. Nano-filled formulation for even, glossy coating

    #. Acetone-free; uses ethanol for consistent application

    #. Helps reduce postoperative sensitivity

    #. Compatible with light-cured composite materials

    #. Light-curing, single-layer application
  • Key Specifications: Storage temperature: 2-28 °C (36-82 °F)
  • Directions to Use: Step 1:
    Dispense the desired amount of Tetric N-Bond into a mixing well and apply it using a disposable applicator (e.g. Vivadent Applicator Brush).
    Step 2:
    Protect the adhesive from light (e.g. VivaPad). Close the bottle immediately after each use.
    Step 3:
    A new disposable applicator must be used for each application.
    Step 4:
    Apply a thick layer of Tetric N-Bond on the enamel and dentin surfaces,using the enclosed application brush.
    Step 5:
    Brush the material gently into the dentin for at least 10 seconds.
    Step 6:
    Avoid insufficient coverage of the cavity and apply additional material, if required.
    Step 7:
    Remove excess material and the solvent by a gentle stream of air so that the adhesive completely covers the enamel and dentin without pooling.
    Step 8:
    Light-cure Tetric N-Bond according to the curing time recommendations below.

Packaging

1 x 6g Bottle of Tetric N-Bond
View full details