VOCO Fissurit F Syringe Refills

Pit &Fissure Sealant

7% OFF

Rs.2,700.00 Rs.2,910.00

Out of stock

SAVE ₹ 90 Delivery Charges | Order Above ₹ 5,000 and SAVE Delivery Charges.


Fissurit F:

Light-curing fissure sealant with fluoride

NDT means non-dripping-technology

Especially for fine-flowing materials
Can be dosed and applied precisely
Without any loss of material

Sealing of pits, fissures and occlusal surfaces for caries prophylaxis
Facing of damaged enamel surfaces
Anchoring of orthodontic appliances
Sealing of composite and cement fillings (protection against moisture)
Restoration of small carious lesions
Repair of small defects in composite and amalgam fillings



FeaturesQuick and direct application from the new NDT-syringe White for application control Excellent flow properties and low viscosity High stability and good adhesion to enamel Perfect marginal adaptation Clinically proven for years Continuous fluoride release Fissurit F in the new NDT-syringe
KEY Specifications

Store Fissurit/Fissurit F at temperatures between 4 °C - 23 °C and protect from light.

Directions To USE

Application: Carefully apply and disperse Fissurit/Fissurit F with a brush or any other suitable instrument. Remove any air bubbles (e.g. with a fine probe). Syringe application: Remove the protective cap from the syringe. Place a new cannula on the Fissurit F syringe. To avoid air bubbles, hold the syringe vertically and press the material up to the tip of the cannula. Fissurit F homogeneously flows from the cannula upon light to medium pressure. In order to ensure the functioning of the non-dripping syringe do not pull back the plunger during or after use. Apply Fissurit/Fissurit F from the margin into the fissure or cavity and let penetrate for 15 - 20 s. Remove any air bubble (e. g. with a fine probe). Light-curing: Polymerise Fissurit/Fissurit F for 20 s per surface and check the sealing. To light-cure this material conventional polymerisation devices are suited. The light output should be a minimum of 500 mW/cm2 on halogen poly- merisation devices and 300 mW/cm2 on LED devices. Re-seal deficit areas, remove excess cautiously (e. g. finishing diamond) and polish if necessary (rubber polisher). Finally apply a fluoride varnish on the treated and neighbouring, preferably on all teeth.


2 x 2g Syringes