1 1

IVOCLAR Tetric N-Bond | Total Etch Dental Adhesive

IVOCLAR Tetric N-Bond | Total Etch Dental Adhesive

Rs. 1,950.00 Rs. 2,746.00 29% Off
Rs. 1,950.00
Taxes included. Shipping calculated at checkout.
inclusive of all taxes
cash on delivery available

Description

IVOCLAR Tetric N-Bond is a light-curing total-etch adhesive formulated for direct and indirect restorations. It is designed to deliver reliable bond strength to both enamel and dentin, supporting long-term clinical success. The nano-filled formulation promotes uniform application and forms a glossy, homogeneous layer that enhances adhesion and coverage.

Tetric N-Bond contains ethanol as a solvent and is free of acetone, which allows for controlled, single-layer application and helps minimize post-operative sensitivity. It is compatible with a wide range of light-cured restorative materials and is intended for use following enamel and dentin etching.

Information

  • Brand: Ivoclar
  • Features: #. Total-etch adhesive for direct and indirect restorations

    #. Reliable bonding to both enamel and dentin

    #. Nano-filled formulation for even, glossy coating

    #. Acetone-free; uses ethanol for consistent application

    #. Helps reduce postoperative sensitivity

    #. Compatible with light-cured composite materials

    #. Light-curing, single-layer application
  • Key Specifications: Storage temperature: 2-28 °C (36-82 °F)
  • Directions to Use: Step 1:
    Dispense the desired amount of Tetric N-Bond into a mixing well and apply it using a disposable applicator (e.g. Vivadent Applicator Brush).
    Step 2:
    Protect the adhesive from light (e.g. VivaPad). Close the bottle immediately after each use.
    Step 3:
    A new disposable applicator must be used for each application.
    Step 4:
    Apply a thick layer of Tetric N-Bond on the enamel and dentin surfaces,using the enclosed application brush.
    Step 5:
    Brush the material gently into the dentin for at least 10 seconds.
    Step 6:
    Avoid insufficient coverage of the cavity and apply additional material, if required.
    Step 7:
    Remove excess material and the solvent by a gentle stream of air so that the adhesive completely covers the enamel and dentin without pooling.
    Step 8:
    Light-cure Tetric N-Bond according to the curing time recommendations below.

Packaging

1 x 6g Bottle of Tetric N-Bond
View full details