VOCO Polofil Supra Syringe Refills

For fillings of more than 2 mm, apply and polymerise in layers (cure each layer for approx. 40 - 60 s). To light-cure this material conventional polymerisation devices are suited. The light output should be a minimum of 500 mW/cm2 on halogen polymerisation devices and 300 mW/cm2 on LED devices. The curing depth, depending on the shade, is approx. 2 - 5 mm, when polymerised for 60 s. The curing depth is approx. 2 - 3 mm for translucent shades, if light-curing is done through enamel (approx. 1 mm). Transparent strips, crowns and/or Iight wedges should be used. Care should be taken to ensure good marginal adaption. Hold the light source of the halogen light as close as possible to the surface of the filling. If the distance is more than 5 mm, the curing depth may compromise. Polymerisation may be limited to the area of the cone of light only. Insufficient curing can lead to discolouration and pulp irritation. The filling can be finished and polished immediately after removing the transparent strips/crowns (fine or extra-fine grain diamond, polishing discs). During finishing and polishing the filling must be cooled. The margin of the filling, or even better the entire tooth, should be fluoridated as a final step. Polofil Supra can be used for direct and indirect inlays according to the customary methods. The physical stability values can be improved by usual external (additional) curing. Store at temperatures between 4°C - 23°C. Syringes and bonding material bottles should be closed immediately after dispensing to prevent exposure to light.