VOCO Easy Glaze Bottle 5ML

Surface Sealant For GIC

21% OFF

Rs.4,200.00 Rs.5,346.00

Out of stock

Free Shipping On Orders Above Rs. 2500.00
SKU: AMVC037 Categories: , , Brand:

Description

Nano-filled, light-curing protective coating for surface sealing

Advantages:-

Glossy and aesthetic surfaces
Easy to use
Provides protection against discolouration
In combination with VOCO Ionofil Molar AC / Quick:-

Protects against moisture and dehydration immediately after filling placement
Tooth-like fluorescence
Natural gloss
Indications:-

Surface sealing of glass ionomer cements, provisional crowns and bridges and definitive composite restorations.
Protecting glass ionomer cement surfaces against the effects of moisture and dehydration immediately after placement.
Sealing glass ionomer cement liners/build-up restorations before taking impressions.
Sealing and protecting adhesive interfaces between restoration and tooth structure.
Precaution:

Do not use in combination with materials containing eugenol as they can impair the polymerisation or adhesion of Easy Glaze.
Easy Glaze is volatile. Only use in well-ventilated areas. Keep bottle out of direct sunlight.
Easy Glaze is flammable. Do not use near open flames or ignition sources.
Easy Glaze contains multifunctional acrylates, methyl methacrylate and BHT. Easy Glaze should not be used in case of known hypersensitivities (allergies) to any of these ingredients. – In case of contact with the eyes, immediately rinse with water and seek medical advice. – In case of contact with skin or oral mucosa, immediately remove the material with a cotton pad. Thoroughly rinse affected areas with water afterwards.

Brand

VOCO

Directions To USE

Ensure that the surfaces to be treated are dry. Dispense a few drops of Easy Glaze into a disposable dish. Replace bottle cap immediately after use. Apply material within 1 min. to guarantee that an oxygen inhibition layer does not form. Apply a thin and air bubble-free layer of the material onto the relevant surfaces with the enclosed brush. Light-cure all treated surfaces with a visible light (> 500 mW/cm2, halogen or LED) for 30 s immediately after application. Hold the light source as close as possible to the surfaces being polymerised. Repeat light-curing if the surfaces appear tacky or yellow. Repeat steps 2 - 5 if a second layer appears to be necessary. Where appropriate, check occlusion.

Packaging

1 x 5ml Bottle